afrigaq.blogg.se

3.5 hp tecumseh engine needle setting
3.5 hp tecumseh engine needle setting






3.5 hp tecumseh engine needle setting

When the engine does run, I see some gas spit out of the air intake.

3.5 hp tecumseh engine needle setting

I put my hand on the air intake and while someone else is pulling starter, I don't feel a vacuom on my hand. I pulled the air filter and I can see the primer bulb is squirting gas into the carb. Not sure what compression should be but that seemed OK. I checked for compression and found 60 PSI after 3 pulls. In fact it seems to die when we inject starter spray into carb. When we do get the engine to start, I've spray starter fluid into the air intake (w/o filter) but the engine does not power up.

3.5 hp tecumseh engine needle setting

We can get it started but it will die soon and will stall when we throttle up. However, even with fresh gas and a good cleaned carb, the engine still will not throttle up. I replaced the fuel line as it looked worn. I also pulled the gas tank and cleaned it out with fresh gas. We used wire to clean the 3 small jet holes. The carb had white cake and crud under the welsh plugs. We pulled the carb and thoroughly cleaned it using a rebuild kit. It is also not idling well and will die after only 30 seconds. The engine has a prime bulb and we can get it started with 5 primes but it will bog down and die when we throttle up. I bought a used Murray gokart that has a great frame and a OHH65 model Tecumseh 6.5 hp engine.








3.5 hp tecumseh engine needle setting